Yes, as long as the power supply is 12V DC and at least 1Amp. You can never have too many amps, but never supply more voltage!
Yes. Most reed switches are normally-closed, so depending on your application you might have to set the trigger mode on the PicoBoo to normally-closed too. Either way it will work.
Record the sequence on the PicoBoo but wait 10 seconds before tapping record to save. That will add 10 seconds of “post delay” during which time a sensor will not be able to activate the PicoBoo.
Simply connect a short jumper wire between (-) and (IN) and it will play the program continuously.
The way to do this is to record some silence into the beginning of your audio file.
Yes, the motion sensor is pre-wired with 15 feet of wire.
No, the program will run to completion.
Yes, the 12V power supply included with the PicoBoo controllers will run off of 220V 50hz power as well as 110V 60hz.
Yes, you simply connect a short jumper wire between (-) and (IN).
The PicoBoo and BooBox controllers can run off of a 12V battery. We recommend one with high amperage such as a car, motor cycle, or alarm system battery.
If you are using the 1Amp power supply that came with the PicoBoo it is not large enough to also power the large 1/2" valve. You need to go up to a 12V 5A power supply.
From $187.49 Regular Price $206.05
To $329.65 Regular Price $362.28