Join Free or Sign in
Shopping Cart 0

Wireless Trigger (2-Relay)

Out of stock
Remotely trigger up to TWO devices.

As low as $0.00

The module has two relays (7 amps max per) on screw down terminal blocks. PicoBoos, BooBoxs, lights, or any other device that can be triggered from a relay can now be activated wirelessly. Use with all FrightProps controllers and audio players or your own devices with trigger input.

Package Includes:

  • 1 x Control Switch Board with two 7-amp relays on it
  • 1 x Remote Control with two buttons (red is relay 1, gray is relay 2)

Requires a 12VDC Power Supply. If you are powering from another device (such as a PicoBoo) then you will not require one.


Control Switch Board:

  • Operating Voltage: DC 12V
  • Max. Load: 7A Per Relay
  • Working Frequency: 315MHz / 433MHz
  • Encoding Type: Fixed Code
  • Output Mode: Two switch signal
  • Size: 50 x 70 x 18mm / 1.97 x 2.76 x 0.71 in
Remote Control:

  • Working Voltage: DC 12V (23A/12V battery)
  • Working Current: 10mA
  • Power: 10mW
  • Transmission Frequency: 315MHz / 433MHz
  • Oscillation Resistance: 4.7MΩ / 3.3MΩ
  • Transmission Distance: 650ft / 200m
  • Encoding Type: Fixed code
Please Note:

  • Actual antenna range will vary greatly depending on the installation and operating environment
  • All units use the same frequency and there is not a way to change that. What this means is that two units cannot be used in the same location and be triggered separately
Write Your Own Review
You're reviewing:Wireless Trigger (2-Relay)
Your Rating
Customer Questions
With this wireless controller, do the buttons on transmitter act as off/on switch or momentary?

The wireless unit is user configurable for momentary, latching, and signal interlock.

  • Momentary: The relay activates when the button is pressed and deactivates when released.
  • Latched: When button is pressed the relay stays on until the button is pressed again.
  • Signal Interlock: Flip flops between relays. For example: press A and relay A stays on even if A  is pressed again. Press B and then relay A turns off and B stays on. Then button B does  nothing until button A is pressed. And so on.

Are these waterproof, can it be out in the rain?

These are not waterproof and must be protected from all moisture.

What kind of battery used in the remote and can it be replaced?

The battery is a “23A” and is replaceable.

There are currently no specific videos for this product. Visit our YouTube channel for many great videos.
For assistance with this product visit the Support & Training Center or Contact Us