Join Free or Sign in
Shopping Cart 0
$0.00

7/16 Bore Double End Rod

SKU
HB-2A69
Built-To-Order
Stainless Steel Body Double Rod End Cylinders are great for applications that require two shafts.

Requires CompressorThis item requires an Air Compressor. Not included!

Build-To-OrderThis product is built when ordered and can sometimes take several days or weeks to ship. Please contact us if you require an exact ship date.

From $44.18

To $60.10

Customize 7/16 Bore Double End Rod
Your Customization
7/16 Bore Double End Rod
7/16 Bore Double End Rod

In stock

$44.18

Summary
    Our goal is to make it easy and fun to use pneumatics. If you run into any problems or have any questions please contact us, we are here to assist you!

    Selecting Accessories We have created an easy to use part lettering system to make it easy to locate parts for your cylinder. Locate this cylinder's Easy Code in the table below. Look for that Easy Code (letter) next to the cylinder part in the Cylinder Accessories Section of our web site.

    Selecting Fittings To locate the correct Fittings with proper sizes for your cylinder locate the Air Port Size in the table below and match the fitting size to that. The most common fittings used to connect air to the cylinder are Male Connector Push-On and Male Swivel Elbow. You can also purchase a Cylinder Hookup Starter Kit which has all of the fittings, airline, and solenoid valve.

    Calculating Force To calculate cylinder force take the Power Factor (push or pull) and multiply by the amount of air pressure (psi) that you will be supplying to the cylinder. For example; If the Power Factor: Push = .44 and the pressure = 100psi then the push force of the cylinder will be 44 pounds of force (.44 * 100 = 44).

    More Options Available We have many additional options for these cylinders. Some of these include; internal bumpers (for noise reduction), rotated air ports, embedded pivot pin (brass pivot bushing is standard), flouresoelastomer seals (for superior chemical resistance), magnet for sensing switch, . Please contact us if you require any of these special options.

    Write Your Own Review
    You're reviewing:7/16 Bore Double End Rod
    Your Rating
    Customer Questions
    Can I spray paint the pneumatic cylinders?

    Yes, all parts of the cylinder except for the shaft can be painted. Be very careful not to get any paint on the shaft as it will effect performance!

    Can these cylinders be used under water?

    Yes.

    Can I hook up more than one pneumatic cylinder to the same solenoid if I want them to go off at the same time?

    Yes, see this document on how to do so.

    Do the double ended rods push out and retract from the middle?

    The shaft is one piece that goes all the way through the cylinder body. When the shaft is pushing out of one end it is retracted on the other.

    Is Stroke length for both sides or total length.So if stroke says 5", does this mean 5 inches on both sides or 2 an half on each side?

    The full stroke length is available on both sides.

    Video 1

    For assistance with this product visit the Support & Training Center or Contact Us