The module has twelve relays (7 amps max per) on screw down terminal blocks. PicoBoos, BooBoxs, lights, or any other device that can be triggered from a relay can now be activated wirelessly. Use with all FrightProps controllers and audio players or your own devices with trigger input.
1 x Control Switch Board with twelve 7-amp relays on it
1 x Remote Control with twelve buttons
Requires a 12VDC Power Supply. If you are powering from another device (such as a PicoBoo) then you will not require one as you can draw power from that.
Operating Voltage: 12V
Operating Current: ≤10mA
Frequency: 310MHz, 315MHz, 418MHz, 433MHz
Transmitting Power: 10mW
Transmitting Distance: 100M
Encoding Type: PT2262, EV1527, HCS300 rolling code
Control Switch System:
Operating Voltage: DC12V
Quiescent Current: ≤6mA
Operating Frequency: 315MHz 433MHz
Receiver Sensitivity: -105dBm
Output Current: ≤10A
Size: 97 x 77 x 26mm / 3.81 x 3.03 x 1.02in(L x W x H)
Actual antenna range will vary greatly depending on the installation and operating environment
Write Your Own Review
With this wireless controller, do the buttons on transmitter act as off/on switch or momentary?
The wireless unit is user configurable for momentary, latching, and signal interlock.
Momentary: The relay activates when the button is pressed and deactivates when released.
Latched: When button is pressed the relay stays on until the button is pressed again.
Signal Interlock: Flip flops between relays. For example: press A and relay A stays on even if A is pressed again. Press B and then relay A turns off and B stays on. Then button B does nothing until button A is pressed. And so on.
Are these waterproof, can it be out in the rain?
These are not waterproof and must be protected from all moisture.
What kind of battery used in the remote and can it be replaced?
The battery is a “23A” and is replaceable.
There are currently no specific videos for this product. Visit our YouTube channel for many great videos.