Join Free or Sign in
Shopping Cart 0
$0.00

Laser Swamp - Individual Laser Module

SKU
FF-LASER-SWAMP-MODULE
In stock
Individual Laser Module from the Laser Swamp laser/fog effect.

As low as $64.99

Customize Laser Swamp - Individual Laser Module
Your Customization
Laser Swamp - Individual Laser Module
Laser Swamp - Individual Laser Module

In stock

$64.99

Summary

    Specifications:

    Laser Swamp - Individual Laser Module - Red
    100 mW / red 650nm laser module: Diameter 16mm * Body Length 68mm

    Laser Swamp - Individual Laser Module - Green
    50mw / green 532nm laser module: Diameter 18 * Body Length approx 80mm

    Laser Swamp - Individual Laser Module - Blue
    100mW / blue 450nm laser module: Diameter 16mm * Body Length 68mm

    The beam angle is 135 degrees. Brightness will vary according to the amount of haze being refracted by the laser beam, but we’ve found that the brightness with haze present starts to diminish after 7-8 feet. Overlapping beams are the best strategy to cover spaces larger than that.

    HOW TO CONSTRUCT YOUR LASER SWAMP

    The following are some details based on a laser swamp effect set up for a tradeshow and may be helpful in setting up your own laser swamp!

    "We started with a flat black room 10' wide x 16' long. The height is non critical; the demo was 10', but it could have been lower to make it easier to decorate with materials to brush people in the face. The width of the room is more important and the laser light tends to taper in strength when refracted through the haze. This varies with the amount of haze in the room but after about 7 ft the effect become faint. We mounted 4 lasers in the corners and two in the middle of the 16' walls. These were mounted belly button high as a personal preference. You want enough height to allow the actor in the black skin suit room to work below the lasers, but you don't want to expose shorter patrons to laser light in their eyes. There were two 36" wide doors in the middle of the 10' wall sections with 8" black PVC vinyl strip material("fear flaps") to block light and minimize the haze loss. We had a small fan just off of the entrance pulling some fresh air into the room the accentuate the swirl of the haze in the lasers to make the effect appear more fluid like. We decorated the room to visually distract people and focus their attention to allow the actor to work undetected with use of an animatronic witch prop to draw peoples attention."

    Write Your Own Review
    You're reviewing:Laser Swamp - Individual Laser Module
    Your Rating
    Customer Questions
    No Questions
    There are currently no specific videos for this product. Visit our YouTube channel for many great videos.
    For assistance with this product visit the Support & Training Center or Contact Us